Sign in to Portal Try Free for 30 Days

Setup Guide

Screen setup guide: from PIN pairing to going live

Device selection, mounting, network requirements, PIN pairing and the first broadcast: a step-by-step guide to bringing a screen live from scratch.

1. Choosing the device and screen

A 10-inch class touch panel is recommended for a door panel and a 32 to 55-inch commercial display for a corridor board. Commercial (24/7) panels last far longer in continuous operation than consumer televisions.

2. Mounting and power

Door panels are mounted slightly below eye level, on the door handle side. If PoE is available, a single cable provides both data and power; otherwise a power socket and a network point are planned together.

3. Network requirements

It is enough to allow the screens' outgoing HTTPS traffic to the dashboard. No inbound connection or static IP is needed. A corporate device VLAN should be preferred over the guest network. Time sync with NTP must be on; the wrong time shows the wrong meeting.

4. Pairing with a PIN

The app shows a PIN the first time it is opened. In the dashboard, a new screen is created in the Screens section, its type is chosen (Meeting, General Meeting, Info, Survey, Digital Signage) and the PIN is entered. The screen connects within seconds.

5. Linking to a room or group

A Meeting screen is linked to a room, a General Meeting screen to a floor or room group, and Info and Digital Signage screens to a playlist.

6. First broadcast and verification

Create a test meeting and confirm that it appears on the door screen; check in and watch the status change. The online status and last connection time of the screen are tracked from the Devices list.

7. Rollout

When one floor runs smoothly, the same configuration is applied to the other floors as a template. Using a floor-room-type pattern in screen names keeps the inventory readable.

We use cookies to improve your experience. You can change your preference any time. Cookie policy